New 5 lug disk setup 14" rotors cobra calipers, tubular front k-member and a-arms, upgraded brake booster diy driveway paint job and the madness continues...
 |
| home made LED 3rd brake light |
 |
| fixed the notorious broken cluster tabs |
 |
| making new door cards |
 |
| installing viper 5901 remote start 3way pager alarm |
 |
the 16" Ponies getting new paint |
 |
| tracing a transmission leak |
 |
| new smoked lights were a gift. I didnt like them at first to gangster for my taste but I got used to them. |
 |
| alternator gave up the ghost on the old bay bridge |
 |
| making some space for new amp to hide under back seat |
 |
| cut support bar and flipped it over removed some foam and boxed the inside corner of frame to make it fit |
 |
| fan clutch needed to be replaced it was stuck (un-clutched) and warm up was taken forever so... |
 |
| hmm… dont think the torque boxes are supposed to flap in the wind?? |
 |
| welding home made battle boxes in and repairing some of the side effects of pre-owner-ignorance |
 |
| who loves to replace a heater core more than me? |
 |
| since its out why not refresh everything.. |
 |
| idk how this went unnoticed on purchase day?? |
 |
| radiator support was much worse before this picture. New maximum motorsports strut tower and k-member braces added |
 |
| since its on the bench anyway might as well repaint it and fix the bondo filled hole from where the ford emblem was removed by p.o |
 |
| 2002 cbr f4i in the backround. easily accomplished roll-on wheelies in 1st gear. impresive for 600cc |
 |
| ridin' on gold ones! |
 |
| for a week then went back to the anthricite silver or whatever its called |
 |
| metal fatigue. great. here we go... |
 |
| at the middle of back seats where driveshaft meets pig... |
 |
| more in the center of the bulkhead and tranny tunnel intersection... |
 |
| and yes it goes all the way through! notice the factory seat belt reinforcements to make your seat belt less likely to rip-out of the floor in an accident |
 |
| not easy to remove the galvanizing coat and weld the tear closed w/o burning through all the spot welds holding the S frame and trunk floor together were pulled apart also... |
 |
| added 4 bolts to help pull things back into place before welding... |
 |
| DIY torque box reinforcements from template I found online... |
 |
| welding practice. this car is my welding college.. |
 |
| S-frame and pinion snubber could never agree on anything so they went their separate ways... |
 |
| welded up and primed... |
 |
| welded primed and top coated black (semigloss) |
 |
| with all the carpets out what better chance do you get to… rewire the interior!! |
 |
| sorta regret not doing thru-floor subframe connectors when the opportunity arose but at this point I was over it... |
No comments:
Post a Comment